applicationsla.blogg.se - Fusion 360 for plasma table

Plasma cutting, is a melting process that uses plasma and an outside power source to create an electric arc between the electrode and the metal being cut to melt and eject it from the cut. This project has no affiliation with any of those companies or projects.Plasma, as known to be the fourth state of matter, is a super-heated gas flow that is formed when compressed air or gas (like nitrogen or argon) make contact with the electrode (which is at the tip of the cutting torch) and ionise to create plasma. MillRight, Hypertherm, GRBL, Fusion360 and Mach3 are all trademarked by their respective owners.

By using this code you accept full responsibility for any damage to yourself, machine or projects. I've tested this code on my own machine (MillRight Mega V XL with a Hypertherm 45xp), but no guarantees or warranty are provided. This code is based on published post-processors available here:

Passes - Compensation Type: In computer.

This will vary by your plasma cutter, so see your factory manual.įor Hypertherm plasma cutters, you can find the machine torch cut chart here: 2D Profile I'm setting up a separate tool and saving them to my cloud library for various metal thickness. With plasma cutting you will need to add a tool with speeds and Kerf width based on the material you are cutting. Setup your project as normal, just make sure you set the following to avoid errors. When you create a post, select browse and point to the folder where the cps file is saved. You can actually just store the grbl_plasma.cps file anywhere.

See this knowledge base article for details: This should make it available under the Personal - local library. Install RecommendedĬopy the grbl_plasma.cps into your personal post directory. Support Z movement with pierce height and delay for lead-ins. Fusion360 Post processor for grbl based plasma cutters.